This website uses cookies

Read our Privacy policy and Terms of use for more information.

When I asked about your biggest pressing struggles, about 1 in 4 of you named browning or fading.

So that’s where my new Q&A series starts. Here are 10 of your questions, with the answers I’d give you if you were in my studio.

1. I change the paper all the time, and the flowers still turn brown. What am I doing wrong?

Look at your paper and your flowers first.

Browning comes down to how fast moisture leaves the flower. The usual culprits:

  • Thin paper, or too little of it. Blotting paper pulls water out faster than copy paper. Whatever you use, use plenty above and below.

  • Changing too soon. After 1 day, a flower is still soft and tears when you lift it. Give it about 2 days before the first change.

  • Thick flowers. Layers of petals trap moisture in the center. Thin them out, or press the petals one by one.

  • Parchment or wax paper. Skip both. They hold moisture in.

If the brown is in one spot where you handled the petal, it’s probably a bruise.

7 reasons why pressed flowers turn brown walks through every cause.

2. The flowers I typically press are past their prime. Will the color fade faster?

Most likely, yes.

I haven’t found a study on pressed flowers specifically. Plant scientists have studied how petals age, though, and their findings line up with what I see in my studio:

  • There’s less color to start with. In a study of 8 rose varieties, pigment peaked when the flowers were fully open and dropped as they aged.1

  • The color has already started to shift. Red rose petals turn bluish before they wilt, because the sap inside the petal becomes less acidic as it ages.2

  • Browning gets a head start. As a petal ages, its cell membranes break down,3 and the enzymes behind browning become more active.4

Bridal flowers often have a long journey behind them, and the time from cut to press can stretch into weeks. A petal that’s already failing keeps failing in the press, and it almost always browns.

You can still get good results:

  • Rehydrate first. Remove water tubes and damp wrapping, give the stems a fresh cut, and let them drink for a couple of hours.

  • Pull wilted or bruised petals before they go in.

  • Use your fastest drying method. The quicker the water comes out, the less time browning has to take hold.

  • Pick younger if you grow your own, before the center goes fluffy with pollen.

If you press for clients, tell them upfront that older flowers may shift sooner (more on that in question 10).

3. Why do white roses and lisianthus from wedding bouquets get brown streaks, even when I press the petals one by one?

White shows everything.

Most white flowers have no white pigment. Tiny air pockets in the petal scatter light, and your eye reads that as white. As the petal dries, those pockets collapse and any hidden yellow or green comes forward. Leftover moisture also shows up on a white petal long before it would on a red one.

What helps:

  • A short microwave step first for thick or fleshy whites. It lowers the browning risk. The natural shift toward ivory will still happen.

  • An earlier first paper change, at 36 to 48 hours, then a couple more changes after that.

  • Deconstructing any flower with several rows of petals.

My white flowers guide sorts whites into the reliable, the changing, and the difficult.

4. How do I keep yellow flowers from turning brown?

Check where the brown starts. On most yellow flowers, it’s the center.

Open-faced flowers like daisies, calendula, and feverfew hold moisture in their centers, and a hard press crushes them. That’s how my feverfew’s cheerful yellow centers went flat and brown in my traditional press.

What fixed it:

  • Cotton pads. They absorb more than paper and cradle the center. My feverfew came out bright yellow. (These are the pads I use.)

  • Picking younger, before the center goes fluffy with pollen.

Some yellows fade no matter what. Yellow and orange ranunculus and sunflowers lose color within months. That’s the pigment, and no technique changes it.

The full method is in my cotton pad post.

5. Calla lilies and other thick flowers turn solid brown in my wooden press. Do I need a microwave press?

Often, yes.

Thick, water-heavy flowers like calla lilies, lilies, and orchids hold on to their water. A wooden press can’t pull it out before browning sets in.

That’s where combining methods helps:

  • Microwave first to pull out the first heavy wave of moisture.

  • Stop at halfway dry. Push it further, and the petals thin out and look cooked.

  • Finish in your wooden press for a smooth, natural flattening.

I recommend the Microfleur microwave press for its durability, and my microwave press guide has the step-by-step.

6. A framed piece faded within a few months. How long should pressed flowers keep their color?

Every pressed flower fades eventually. Even when displayed well, expect visible fading on untreated flowers after a year or so.

If a piece faded within a few months, look at:

  • Light. Direct sun fades even a well-pressed flower faster than anything else.

  • The flower. Deep, saturated colors hold up. Pale ones wash out fast, and some, like ranunculus and pastel tulips, fade no matter what.

  • The green. Stems and leaves go first.

To slow it down:

  • Frame it behind UV-protective or museum glass. My dahlias held their color for more than 4 years behind museum glass.

  • Hang it out of direct sun.

No UV-protectant sprays will stop the fading. If color retention matters to you or your clients, you’ll need to consider color correction.

7. Stored flowers faded, and they never saw daylight. What happened?

Usually it’s moisture, or the flower’s own chemistry.

  • Moisture. Pressed flowers reabsorb humidity from the air, and whites and pastels brown fastest. Keep storage at 40 to 50% humidity (an inexpensive hygrometer will tell you), and add silica packets to your boxes.

  • Chemistry. Some flowers keep shifting color in a dark drawer. That’s their pigment.

  • Acid. Cardboard, foam board, and some glues can migrate acid into flowers. It shows up over years, so if yours changed within months, check the humidity first.

My boxes of pressed flowers have sat in closed cabinet drawers for 5 years with zero issues (more in my storage guide).

8. A few months after I delivered a shadow box, my client sent me a photo. The 3D flowers had faded, and some had turned brown. What happened?

Most of the time, humidity works its way back in and light finishes the job - especially in 3D flowers. A piece can leave your studio looking perfect and still change on its new wall.

A dried 3D flower also has far more exposed surface than a flat one, and those petals keep drawing moisture from the air. Over a few months, they soften, darken, and start to brown. Whites and pastels show it first.

For the next piece you deliver:

  • Make sure they are crispy-dry before framing. If the unframed artwork fits in a dehydrator or electric oven, you can dry it at 100F/38C or less for about 30 minutes.

  • Seal it, and use UV-protective glass. A sealed back keeps room air out, and museum glass blocks most UV.

  • Tell your client where to hang it: Out of direct sun, and away from bathrooms and kitchens. A short care note in the box helps.

  • Expect some shift. Silica-dried white ranunculus settles into a soft ivory, and garden roses shift too.

Set expectations before the piece leaves your studio. Telling clients upfront how their flowers will change makes the whole conversation easier (more on that in question 10).

9. Can a browned or faded flower be fixed without it looking fake?

Browning is permanent, so the goal there is to hide it. You can bring back faded color, and it can look natural.

Match the method to the flower:

  • Faded flat flowers with some color left: alcohol markers. The ink is translucent, so you still see the veins and texture. In my fading experiment, the marker-treated flower stayed the brightest.

  • White or browned flowers: pan pastels or floral color sprays. Both are opaque, so they cover what markers can’t.

  • 3D flowers: Airbrushing or sprays (though not as effective as airbrushing).

I compare all 5 methods in 5 ways to color-correct pressed flowers.

10. I’m scared to sell my work because I know it will fade. Should I still sell it?

Yes. Just decide what you’re promising, and say it out loud.

Every buyer eventually asks, “Will it stay like this?” Your answer depends on which approach you commit to:

  • Natural: “Natural flowers change.” A little shifting is proof the flower is real, and many buyers love that.

  • Color corrected: “It will look much like this for years.” To promise that, you need to protect and correct color.

Some artists offer both, and others choose one.

Across 1,200+ frames and resin pieces, most of my clients choose color correction, so I color-correct everything in my paid work. I leave my natural work untouched.

A word of caution: correct every flower in the piece, or none at all. Coloring just some of them leads to uneven fading.

The only real mistake is letting a buyer assume a permanence you can’t deliver.

What should I answer in the next installment of the Q&A? Tell me in the comments!

As an Amazon Associate I earn from qualifying purchases. Some links on this page are Amazon affiliate links. If you purchase through them, I earn a small commission at no extra cost to you. I only link to products I personally use in my own studio.

Sources

  1. Schmitzer, V., Veberic, R., Osterc, G., and Stampar, F. (2010). Color and phenolic content changes during flower development in groundcover rose. Journal of the American Society for Horticultural Science 135(3). Read the study

  2. Oren-Shamir, M., Dela, G., Ovadia, R., Nissim-Levi, A., Philosoph-Hadas, S., and Meir, S. (2001). Differentiation between petal blueing and senescence of cut ‘Mercedes’ rose flowers. The Journal of Horticultural Science and Biotechnology. Read the study

  3. Suttle, J.C., and Kende, H. (1980). Ethylene action and loss of membrane integrity during petal senescence in Tradescantia. Plant Physiology 65(6). Read the study

  4. Yeamsuriyotai, K., et al. (2025). Formulation and evaluation of nanoemulsions from Jasminum officinale essential oil for controlling postharvest browning and maintaining quality in jasmine (Jasminum sambac) flowers. Frontiers in Plant Science 16. Read the study

Reply

Avatar

or to participate